2002 Chevrolet Avalanche "remove intake manifold chevy" Questions

...is located on top of the engine at the rear. You will need to remove the top of the intake manifold to get to it. this might be helpful Replacing oil pressure sending unit on 2003 Chevy ...

...intake manifold. The good news is this is a fairly easy fix as far as removing the intake goes. I assume you have the 5.3 engine? In the many cases where i have replaced the little sensors the best ...

...the go to the underside of the intake. I need to know the proper steps to remove the upper intake Thank you http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008effd this should ...

...order to fix the leak,the black plastic cover over the intake manifold needs to be removed or at least loosened.Any idea how this cover can be removed? remove oil cap steam an it should just lift ...

...remove the intake manifold, because both of them are located under it. it is best to replace both knock sensors at one time, and you will need an intake manifold gasket too. I have a 2001 Chevy ...

remove intake manifold on 94 Chevy 5.7L TBI I have removed all the bolts on the edge but the intake still won't braek loose. There are recessed allen head bolts on top of the manifold. Do they need to

intake manifold located on a 1997 Chevy 2500 van? The upper part of the intake manifold is the plastic part of the assembly, it's held on with small 10 millimeter headed bolts. NOTE: This dosen't have

...Remove the engine cover to access the intake manifold and manifold gasket. Disconnect the throttle body inlet duct from the engine. Twist off the radiator cap to allow draining of the coolant to flow ...

...remove the intake to get to the sensors. 95% sure manufacturers place the knock sensor on the intake manifold-it's where the knocking happens-(fuel/air mixing). Mine was on the driver's side of the ...

...Remove the upper intake manifold. INSTALLATION: 1. Install the upper intake manifold gasket. 2. Install the upper intake manifold. Use care not to pinch the injector lines between the upper and lower ...