2001 Chevrolet S-10 "relay starter" Questions

...like a sticking relay causing a over load I belive the relay is sticking closed allowing the starter to engage but not fully open to disengage try observing the starter and solenoid more closley

...relay ,starter nothing Replace elec pump relay fuel filter starter and nothing could it be in wiring? not elec person not getting gas in EFI Have you tested the pump relay to see if it is sending ...

...Replaced N. Safety Switch.....Recently replaced pugs and wires..truck ran great drove to work then would not start. Thinking about replacing Ignition Switch or Starter Relay? bench test starter ...

starter is 12.5 V on batt terminal and 11.6 to the smaller relay terminal. Checked relay and it checks out ok. This one has me scratching my head. Any fresh ideas would be great. try turning the crank

...starter relay.you may just have a bad relay or blown fuse. usually the clicking comes from a bad starter or a bad starter colenoid on the starter.sorry,but i do need to cover all bases,just in case ...

...a start the truck starter relay may be stuck solenoid sticking if starter has been replaced may need to shim starter some reman. starters the gear spacing is too tight beteen starter and fly ...

the starter relay. Check with manual and replace the relay. Sometimes you can get some temporary relief by tapping the relay or removing it and replacing it. If that doesn't work you'll need a new one

...starter itself, still won't start. Any ideas? look for an ignition relay in the relay box under the hood can you turn the engine by puting a wrench on the harmonic balencer? if not then the engine is ...

...it a fusable link Where is it located pull the starter,, place the neg terminal on the case for the starter, and hit, the post of the starter relay, if it engages ,, its ok, your problem is ...

...Starter Relay, Starter Solenoid, Ignition Switch, or Clutch Safety Switch. Check that your starter is getting 12 volts when the key is turned to Start. Check the Starter Relay to see if it clicks. ...