...new head gasket put on it it has a new thermastat new heat sensor radiator cap air filter water pump and more. it dosent always over heat but it rides rougher than it use to it also makes a horrible ...
...new seal onto the drain tube. Attach the core cover from the rightside, sliding it up and forward into position. 2. Align the draintube with the front dash hole and the core cover holes with the HVAC ...
...new seal onto the drain tube. Attach the core cover from the right side, sliding it up and forward into position. #Step 2 Align the drain tube with the front dash hole and the core cover holes with ...
Question about Chevrolet Impala
...water pump serpentine belt, etc. and I believe the belt needs to be tightened or changed. I had my battery go dead on me 2X and I replaced it 7 days ago. It had a bad cell. However, the old and new ...
...new water pump put in. The car was doing fine two days later i notice when im driving the temp gauge moves off the halfline to the next line above it the needle stays there the fans come on and stays ...
Question about Chevrolet Impala
...put my Impalla in the Garage for this problem and the mechanic checked all hoses and all hoses were hot except the one going to the heater core. He bled the hoses by letting the car idle with the ...
...put in the new pump you need to put grease on the splines. battery disconnected drain coolant take out the electric fan take off the serpintine belt use a large screwdrive or equivlent to hold the ...
...that hold water pump to block 2 on each side and thats it. Clean old gasgets off engine block and bolt on new pump with new gasgets witch will come with new pump. Put back to gether in reverse
Question about Cars & Trucks
...put in a new water pump and themostat and now it's overheating and draining the water from the thermo intak hose I think there may be two different pumps for these engines and one runs backwards from ...
...put all back together. aftermarket water pumps do not come with theermostat, dealer pumps do. remove your belt tensioner from old water pump 3- 15mm bolt, two different sizes and install on your new ...
1,706 questions posted
Usually answered in minutes!
2,177 Questions
1,746 Questions
1,386 Questions
1,400 Questions
1,452 Questions