...emergency brake adjuster. I turned the adjuster and tightened the brakes, then I turned the adjuster the other way until it stopped and the rotor still will not come off. Do you have any suggestions? ...
Question about Buick Rendezvous
...emergency brake every time I park. Now I am having problems with the emergency brake alarm going off when I am driving. If I wiggle the emergency brake it will stop for a little while and then starts ...
...emergency brake. I have taken the tire off now and the brake pad is tight and the emergency brake cable is released. I'm not sure what to look at and the emergency brake cable seems like it is pulled ...
Question about Cars & Trucks
...emergency brake pads what could this be fro Oil or grease on emergency break pads what is this from The only things I can think of at the moment, is either brake fluid or rear end fluid. You havea ...
Question about Buick Rendezvous
...emergency brake light and my traction control light is on steady. My AT oil temp light is blinking and my emergency brake light is blinking and the traction control light is on steady. Please help. I ...
...emergency brake on an 2002 ford explorer behind the disk brake.(rear driver side) First remove caliper slider assembly & caliper. Will need to probably spray penetrating oil around rotor hub. Hit ...
my 1994 sonoma emergency break light stays on, have triple checked and emergency brake is not engaged check oil brake level. or disconnect switch wire at master cylinder hope it helps
Question about Buick Rendezvous
...emergency brake pedal on my 01 gmc jimmy does not hold at all. We have replaced the back brakes & can see hat when the emergency brake is pushed down it engages on that cable back there.But the ...
...emergency brake shoes, inside drum inside rotor. I always engage emergency brake 1 to 2 clicks then ride around the block. That gets rid of rust & ridge on drum. Release emergency brake.Jack up ...
Emergency brake closed to eliminate clearance problems. With some vehicles, the hub will rust and the brake drum or rotor will be bonded together. Penetrating oil, rubber hammer, and rotating the drum
983 questions posted
Usually answered in minutes!
1,091 Questions
757 Questions
481 Questions
276 Questions
88 Questions