...3.3 V6. Died at stop 1993 buick skylark w/ 3.3 V6. Died at stop sign.(tank 3/4 full) Cranks but won't run..unless you use starting fluid. Checked fuel pump and filter and ECM all good. Need to check ...
...V6, looking at your engine: 2 4 6 1 3 5 Coil packs, from the front: 1 4 5 2 3 6 4 Cylinder, from the front: 1 2 3 4 Coil packs, from the front: 1 4 2 3 Regards, matt u need a repair manual from ...
...V6 the firing order is 1,6,5,4,3,2 and the cylinders are numbered 1,3,5 in the front from the passenger side to the drivers side and 2,4,6 in the back from the passengers side to the drivers side. ...
...V6 3.1 transmission wont work in D OR 3RD but will work in 2nd and 1st after i am moving i can move it in 3 and then D You need to have the tranny service. If it is a longtime the fluid could be too ...
Question about Buick Skylark
...3.1 liter v6 changed fuel pump,ignition switch,worked fine for 1 yr.now when you try to start it.it fires,runs 3-5 seconds then dies.whats wrong? is there a security system problem ?its happened ...
...and had a similar problem. I would have it tested first if possible. If u have any other questions abt this car, feel free to send em to me directly, especially if yours has the 3.1
...3.1 SFI v6 engine. The car just stopped on me at a light had to be pushed out of the street. Thought it was the battery but it's not because the lights comes on, also it's not the alternator in which ...
...3.3. v6 that I just replaced the starter on after the original starter gave out...after 3 days it's acting like the starter is junk already...I need to know if there's an inline diode or fuse or ...
...sfi v6 front wheel drive 3.1 v6 are under upper pleunm or upper intake. 6 injectors 3 on each side. have checked usually not a no start, test fuel pressure and take gas sample. stale or water in
241 questions posted
Usually answered in minutes!
346 Questions
224 Questions
182 Questions
143 Questions
87 Questions