1988 Buick LeSabre "replace ignition module 3800" Questions

a ignition module buick lesabre V6 3800 1A Auto shows you how to remove, install, repair, or replace your broken misfiring or damaged ignition coil. This video is applicable to Buick LeSabre 2000-2005

engine stalls my engine stalls then car won't restart i had a mechanic replace the crankshaft sensor my engine still stalls i do not know what to do? Ignition Module is going bad on your 3800 Gen II

...cam sensor, crank sensor, and ignition control module. next time it won't run after it heats up, spray or pour water in crank sensor and see if it will start. I have seen new crank sensors go

...replace anymore til u know the cause--test for spark 1st-it may just be the ignition module--a worn coil--or bad distributer cap--battery cud be too weak and old-or alternator is------fuel pressure ...

...ignition module, coil, and ECM have been replaced.I have the cam position sensor out and am trying to check the cam sprocket for the presence of the magnet but I do not know exactly how to do it.Do I ...

...Ignition control module and the crankshaft position sensor. Best of luck! I followed some advice which solved the same problem for someone else, but it didn't work for me (replacing the Ignition ...

...replace both at the same time to fix. I have a 1990 Buick LeSabre with the 3800 engine. Recently the engine has began to miss under mild acceleration. It is not just a misfire where the spark plug ...

where is the ignition control module located on a 92 buick lasabre 3800 it is behind the harmonic balancer on the passenger side just replaced mine

...WHEN CAR OFF AND THEN START CAR AND SEE SPARK-- SAFEST WAY IF THERE IS NO SPARK- THEN IT IS EITHER THE COIL ITSELF OR THE IGNITION MODULE THAT THE COIL IS ATTACHED TO -- GOOD LUCK AND BE SAFE ...

...ignition module or distributer cap has issues-------the injector driver inside the computer cud be gitten hot etc which can cause shutdown-------get car scanned with a tech ll that runs a data stream ...