...ECT) sensor. Disconnect the sensor electrical connector. Carefully remove the ECT sensor. Fig. Removal and installation of the coolant temperature sensor To install: NOTE Replacement components must ...
...ect sensor,checked relays and fuses. why does may radiator fans only come on if my heater (inside) is on and blowing full blast. if my heater fans are not on the car gets hot Sounds like Clutch in ...
...ECT sensor and the sensor for How to identify the differences between ECT (engine coolant temperature) sensor and the sensor for the temperature panel and their location to one another (which one is ...
Question about Pontiac Aztek
...ECT sensor near the thermostat area. but in Mopar store, the ECT sensor seems to be in a different location in the middle of the hose? Question edited for clarity. Question moved to model category. ...
...ECT)coolant temp sensor have two wire and you can test it by (AVO meter) the two wire :- the 1st is ground from ECM the 2nd is have 5 volt whine disconnect the connector of (ECT) and less then whine ...
...ECT sensor and the intake air temperature (IAT) sensor of more than 100°C (180°F) at start-up. OR ?€¢ The control module detects a temperature difference between the ECT sensor and the IAT sensor of ...
...ECT sensor. On 6.6L diesel engines, remove the alternator. Unplug the harness connector from the ECT sensor. Remove the ECT sensor from the engine. Installation is the reverse of removal. If reusing ...
Question about Pontiac Cars & Trucks
...ECT) Sensor (LY7) In the engine compartment, in the left side of the left cylinder head, between cylinders 2 and 4 Engine Coolant Temperature (ECT) Sensor (L76) Left front of the engine above the ...
Question about Acura Cars & Trucks
ECT sensor, red & white, green & yellow. I need to know, which color wire goes into the plug? Because the two wires broke off of at the plug when I checked the ECT sensor, because the car showed a DTC
Question about Pontiac Aztek
...around the T .stat and ECT sensor and basicly tells the gauge what to read work on resistance dosn't noramly cause a problem unless the connection is bad .Clean it likely be the end of your problem
1,433 questions posted
Usually answered in minutes!
342 Questions
278 Questions
263 Questions
123 Questions
1 Questions