...exaust manifold closest to the fire wall unfortunately it has to be replace. it has an electronic lead to it and is vaccum operated to replace it is not a difficult task. the part can be purchased at ...
Question about Oldsmobile Alero
...exaust in the enging conpartment think it is the catalytic converter but the Hyudai santa fe has two not sure which to replace. If you are getting exhaust fumes in the engine compartment I advise ...
is the exaust manifold the # 1 is left side #2 is right side. they should be located right after the exaust manifold on the pipe it's self. all you have to do is unplug them and remove for replacement
...manifold , you'll need a 1 1/16 crows foot wrench. remove exaust pipe then manifold bolts then manifold .clean both surfaces to insure good seal reassemble.this is a 4 to 8 hr. job best left to a
exaust manifold on a 1991 ford bronco 302-v8 start by removing nuts from exhaust pipe on the underside, then remove the 8 bolts that hold manifold to engine and pull it up. make sure when reinstalling
...exaust on isuzu bighorn (trooper) first section from manifold what do i remove to get to it if you are replacing the small down pipe fron the manifold first remove the middle section and then long ...
Question about Oldsmobile Alero
that connect the exaust to the manifold. Next you must remove the nut and bolt at the first union. Now you can remove the starter and reinstall a new one. Now just attach the exaust and problem solved
Question about Oldsmobile Alero
...exaust manifold. REmove old plug. Install new plug. Not rocket science Remove the manifold to access and drill hole in plug then use a puller tool to pull out or pry bar. Put silicone around new plug ...
exaust manifold and has 2 wires going to it. The engine heats up and the sensor detirmines if the engine is burning too rich ,or too lean.From that signal the computor adjusts the fuel mixture. The O2
...exaust manifold to get to it. i was wondering if there is any other way to do it This is kind of a pain, usually you can get to the top bolt ok. the bottom bolt just has to be loosened, it does not ...
1,875 questions posted
Usually answered in minutes!
1,478 Questions
1,097 Questions
1,065 Questions
830 Questions
662 Questions