...bar or a impact gun to back the center nut off. Once off use the steering wheel puller by inserting the threaded bolts into the threaded holes directly beside the center pin. ease the puller onto the ...
...bar or a impact gun to back the center nut off. Once off use the steering wheel puller by inserting the threaded bolts into the threaded holes directly beside the center pin. ease the puller onto the ...
...lock. First you need to go to the local parts store and get a steering wheel puller and a clock spring compressor tool. You can rent them but just cheaper to buy it and return it. I got mind like 35 ...
...lock brakes.Sponsored LinksBridgestone PromotionGet Either A Reward Card Or Kindle When You Buy 4 Select Ecopia Tires.BridgestoneTire.com/Promo3Remove the nut securing the brake hose bracket to the ...
...bar & pop the seal out. Keep in mind the axle bearing is probably gone too , so that's another procedure. Keep it apart,you'll be glad you did. Removal & InstallationTo Remove: Before ...
bar. Now open the hood, flip up a small door, located just over the light, a bit to the left at the front. Look in down in here and you'll see a nut that the "L" shaped pin goes in. If you look on the
...lock plates should be on the inside facing one another. On the cylinder block near the crankshaft, remove the sealing plug from the lower left side of the engine block. Make sure the engine is at TDC ...
...bar style wrench (non-ratcheting socket wrench) with a helper pipe slid over the end to increase leverage use an axle nut socket to loosen the axle nut without removing it.(these are torqued pretty ...
...lock switch if you have electric locks). Removing the inside handle requires sliding the assembly forward 3/16 inch then removing the plastic retainers on the actuating rods with a flat screwdriver ...
604 questions posted
Usually answered in minutes!
575 Questions
540 Questions
492 Questions
476 Questions
332 Questions