...motor does not operate on any speed, the problem is most likely a bad blower motor or a burned-up control switch. If it only operates on HIGH, the most likely cause would be a bad blower
Question about Oldsmobile Cutlass Supreme
cause the resistor to burn out. The blower motor in your truck has a resistor block with multiple resistor wires. Jun 21, 2023 Why Does the Blower Motor Resistor in My Dodge Dakota ... More here https
Question about Oldsmobile Cutlass Supreme
...be the resistor module? blower resistor is common to burn causeing smell. check with dealer, there may be a campain on this problem. if not. replace resistor and harness (pig tail) and blower
Question about Dodge Cars & Trucks
or tight semi-seized bearings the motor will consume more current and cause the resistor to become even hotter, possibly causing it to fail. The screaming noise is typical of a motor bearing trouble..
Question about Oldsmobile Cutlass Supreme
CAUSE YOUR PROBLEM, OR A BAD RESISTOR. THERE IS NO REAL GOOD WAY TO CHECK THE RESISTANCE OF THE BLOWER MOTOR. hi you probely have a draging blower motor. if it pulling more than 25 amps replace it and
blower motor, then at the resistor. The power comes from the relay, thru the blower switch, then to the resistor, then the motor.The resistor can burn a wire inside causing an open circuit which
...but no ground, The most likely cause would be a burned blower motor resistor. (Ground is supplied through the blower control switch to the resistor, then to the blower.) Replace switch or fan
The blower motor resistor is the culprit.Usually is located near the blower motor.Generally an inexpensive repair.However it is possible that the blower motor may have caused the resistor to burn out
...resistor and blower BURNED slightly in the process, and will need to be replaced all the way back to where they connect to the fuse block. (The wires may have been pinched or otherwise damaged ...
out it is not the blower motor there is a set or resistors that is used to control the speed of the blower motor these resistors tend to over heat and burn up and usually is the cause of a malfunction
919 questions posted
Usually answered in minutes!
571 Questions
488 Questions
387 Questions
236 Questions
203 Questions