...head bolt you need. They will supply it for you Your local auto parts dealer can also supply bolt as well. You may have to purchase a set of bolts as they may not sell them seperaretly. I recently ...
head bolts have to be torqued down in a specific sequence. When the heads are off, make sure they aren't warped. If you know what your doing, it's not to bad, if you don't, you can end up with a major
...torque the head bolts to 22 lb ft... then turn each and additional 90°, then loosen each and REDO to the same specification = 22 lb.ft)+90° (you're actually crushing the head gasket ...
Question about Hyundai Cars & Trucks
...HEAD TIGHTENING TORQUE [1] : 1st sequence: 40 Nm (30 ft lb) 2nd sequence: 60 Nm (43 ft lb) Final sequence: plus 1/2 turn (180°) Here are some additional specifications, thanks ntake Manifold Mounting ...
Question about Cars & Trucks
...head bolts torque: 30 Nm (22 ft-lbs) + 90 degrees + 90 degrees (in 3 steps of 90 degrees each) Main bearing cap bolts torque: 30 Nm (22 ft-lbs) + 90 degrees Connecting rod bolts torque: 25 Nm (18 ...
...head Sure, here are the torque specifications for the flywheel, rod & main bearings, and head bolts for a Mitsubishi Canter 4D32 engine: Flywheel bolts: 77.46 lb-ft (105 Nm) + 90 degrees ...
Question about Toyota Cars & Trucks
torque specs for the cylinder head bolts Head Bolts Step 1-33 Ft. Lbs. Step 2- Additional 90 DegreesI would check in the service manual as well, just to be sure. The torque specifications for cylinder
...Head Bolt Torque... Torque Sequence -------------------- Front | 7 2 4 6 | Of | 5 3 1 8 | Engine --------------------- | 5 3 1 8 | | 7 2 4 6 | --------------------- Step 1 - 12 Point bolts: Torque to ...
Question about Ford Cars & Trucks
...head bolts? not 2.5 diesel The torque sequence and specifications for the cylinder head bolts on a 1998 Ford Ranger 2.5L gasoline engine are as follows: Tighten all bolts in the sequence shown below ...
Question about Toyota Cars & Trucks
...Head Torque: (a) Apply a light coat of engine oil on the threads and under the heads of the cylinder head bolts. (b) Install the plate washer to each cylinder head bolt. (c) Install and uniformly ...
676 questions posted
Usually answered in minutes!
575 Questions
540 Questions
492 Questions
412 Questions
332 Questions