...everytime i put on a new serpertine belt it burns out because it gets caught and just shred if that waterpump pulley is wobbly loose , time to replace the waterpump. Hope this ...
cant get pulley off of waterpump to put new waterpump on only four bolts to remove then give it a smack with a Rubber mallet, is not held on by anything else, in fact I just removed one 2 hours ago..
i have a 1994 oldsmobile cutlass cierra and the waterpump is leaking and i need to know what tools i will need to change it out wrenches and sockets the correct size and something to clean off the old
is running hot quick check coolant level. check your thermostat, it might be sticking (replace). check/replace waterpump. impellers may be dammaged
waterpump pully puller The pully should have 4 bolts holding it to the pump.
little to no heat new thermostat and waterpump that souns typical of a stuck heater control valve. you can try putting the heat on while bleeding the cooling system.
...or the rear of your car , underneath the hood, at the far left, top side of your radiator, the waterpump is about 3 or 4 inches away, in the direction of the rear of your car and above your
how do i replace the waterpump on my 93 cutlass ciera I could walk you thru the steps involved, but the best advice i can give you is to spend about $25 on a manual from your local parts store or ...
of the problem I have the same car 1986 Oldsmobile Cutlass Ciera LS. Heres something to see if your waterpump went out, open the hood, then open the fill cap on the radiator, then turn on your car and
Question about Oldsmobile Cutlass Ciera
...HOUSE YOU UNSCREW THE AND GET THE AIR OUT OF THE COOLING SYSTEM AFTER A REPAIR IS MADE TO! (WATERPUMP) UNSCREW IT ALITTLE BIT WITH THE CAR RUNNING AND ALLOW THE AIR TO BE PUSHED OUT THE
796 questions posted
Usually answered in minutes!
540 Questions
492 Questions
476 Questions
412 Questions
332 Questions