shift cable on the transmission is defective, or could the REVERSE just go, or is both a possibility? The condition of the shift cable has nothing to do with the condition of the transmission. Replace
it trys to shift to 3rd it slipps out of gear, it will shift into rev just fine. Do you know what this could be. TV cable may be possibly stretched and needs adjustment or 3rd gear clutch pack failing
...the steering colomn apart, check at the top of the transmission. Follow the shift cable, it is right on top near the rear, and make sure it just hasn't popped of the manual shift lever of the
Question about Oldsmobile Cutlass Ciera
...cable to stop engine it is a 1994 cutlass ciera six cylinder Sound like a ignition switch failed and its possible that you need replaced. Good luck. Watch this video- Change ignition switch. You will ...
what the prob could be? Find the cable from shifter to tranny, there will be an adjustment screw on it. Turn right to tighten, Also there is also a pin at the end of shift rod that may have broken off
1988 Olds Cutless Ciera transmission linkage the linkage is not working. downshifted into second gear. now only in second gear. would like a picture of the linkage mechanism to get an idea what I need
Question about Oldsmobile Cutlass Ciera
...shift the the trans while you look and see if shifter cable or linkage come loose or not working period look and see if there is a leak or puddle on ground check fluid level not knowing where you are ...
...shift cable end of the shift cable to the transmission shift lever stud ball. Install the retainer to the shift cable and transmission bracket. Feed the shift cable through the floor panel. Lower the ...
...shift cable in a 2000 Cavalier 1 Take the rubber boot off the gear shift inside the vehicle and lift it up, exposing the area where the gear shift and the transmission connect. 2 Look for the shift ...
...shift cable and the shifting arm. A single bolt and nut connect the shift cable and shift arm. 3 Twist the nut connecting the gear shift and the transmission. Use a socket wrench and remove the gear ...
796 questions posted
Usually answered in minutes!
540 Questions
492 Questions
476 Questions
412 Questions
332 Questions