1991 Oldsmobile Cutlass Ciera "crank sensor" Questions

...crank sensor / cam sensor last ignition control moduel the crank posisioning sensor is most likely the problem.Check if your getting spark. the sensor tells the spark cntrol modual when and where to ...

...crank sensor in 89 olds cutlass calais Scottykw I have an 88 Oldsmobile Cutlass Calais quad 4,2.3L needing help locating the knock sensor on my car,rough idling and slow and sluggish acceleration.ive ...

crank sensor. Usually located near the crank pulley behind or under it. Disconnect wires if possible and use a socket to get it out. The crank sensor sends the power to the coil. Good luck cheers from

...crank sensor, ingition modual has been checked. do you have a diagram of the electrical I can look at or do you have a suggestion for the problem. Hi, I had the same problem with no spark at my 1993 ...

crank sensor and inginton module was replaced. What can be the problem ? Also replaced mass air flow sensor and idle control motor I would check the camshaft sensor. If you have spark, pulse, and fuel

...crank sensor too , you replaced everything else ! Parts stores love you ! What's missing after it stops , spark ? Can't be fuel you replaced everything there or did you ? fuel pump relay ! What year ...

and look for fuel.If you don't see any fuel then replace fuel pump.If you see that you have fuel then pull crank sensor out and check for cracks.If you see cracks replace sensor and reset computer

...crank sensor A shop already told me I need to change the crank sensor and ignition module in my 1990 cutlass ciera S and I don't know where in the engine compartment I should be looking CRANKSHAFT ...

crank sensor. The pickup coil will be in the distributor-if you have one. If no distributor, crank position sensor is behind the crankshaft harmonic balancer. If fuel pump and spark are good, you will

...replaced cam sensor, crank sensor ,fuel filter , car cranks then backfires though intake Bad valve timing or sensor/s connections. Read the codes. you will need a repair manual with the codes in