2004 Mazda MPV "holding water" Questions

water pump is good engine wont turn over water pump is good If you're alternator is holding a full charge then check your starter.

...holding the water pump in . Loosen each one a little bit. After all are lose you can then remove them. Remove water pump. Put new gasket on and install new water pump. Hook up hoses to water pump. ...

no heat I have a 2001 Madaz Mpvand the heater and windshield defog had no heat at all, it blow out cold air. the radiator was full antifreeze but I am not sure how long it has been there? what can I ...

My car is bubbling like when i turn it off it only does it every now and then and Its also making a winding sound i have replaced the radiator and the water pump the thermostat . Also we by passed the

...water pump is driven by a pulley on the end of one camshaft. Your confusion stems from the change from the old system, in which a longer belt was used with a tensioner in the traditional fashion, and ...

changing water pump mazda mpv 2000 lx Whatever you do, do NOT bring it to the dealer as most dealers will charge upwards of $650 for what I did in about 2 hours of work in my driveway with a 10 mm ...

...water pump IT will have a big aluminium centre to which the fan is bolted. The hub is designed to start to lock up when the radiator gets hot and they were introduced to save fuel. However they will ...

the water in my mazda bongo wont circulate top hose gets very hot while bottom hose stays cold , heater wasnt working but now managed to get heater working after bleeding the system but bottom hose ...

over heating The engine is kept cool by a liquid circulating through the engine to a radiator. In the radiator, the liquid is cooled by air passing through the radiator tubes. The coolant is ...

...water is not circulating? Nornally the hose will warm up but not hot with a circulating system. the therostae could be installed upside down or be bad. You should install a therostate with a asprin ...