Question about Dodge Dakota
...power all the time at the relay plug No signal from ecm (computer) Crank-no-start can also be caused by the Cam sensor or the theft deterrent system (the Theft light will be lit while
Question about Dodge Dakota
...crank shaft sensor that was bad. I replace the sensor. The truck still won't start Check all the fuses all ok .Checked all relays all ok. Truck won't start. Which engine, do you have ...
Question about Dodge Dakota
Power · The engine may be harder to start · The engine may stumble or stall. Cam Sensor Failure Causing no Start or Stalling : Dodge ... RepairPal.com https://repairpal.com > Problems > Dodge > Dakota
power wire at the pcm and it has 12volts. I really dont know what else to look at. Does anyone have any ideas. maybe the crank sensor? If yours is similar to my 92 shop manual (I have a 92-5.2 V8) The
wont start, fuel pressure OK, NO spark, NO power to coil, why? most likely a crank sensor, need to scope it to see if its putting out a good signal. Generally with no RPM signal it points to this part
...power and sometimes shuts off. the engine will not start again until engine cools down. when engine is warm an not tarting there is no fire and when connected to a scane tool there are no rpms ...
...CRANK SIGNALS..WHEN CRANKING..HOLD YOUR TEST LIGHT ON DG/OR WIRE AT COIL AND HAVE SOMEONE JUST TURN KEY ON..YOU SHOULD GET POWER FOR 2-3 SECONDS..IF IT DOES,THE CIRCUIT TO THE COIL IS OK..CHECK ALL ...
...so if on power is at the coil once the engine dies this is normal check cranking it should return but no spark then test the crank shaft sensor iit is on back of engine passenger side bolted to
Question about Dodge Dakota
...and crank sensor,still no fire? start by testing coil for power ,if no power then in the fuse panel you should have anything up too three fuses marked CONT and they should be about 10 amp ,check ...
If your 'service engine' light comes on when you turn the key on then the PCM is getting power. Also, some PCM's won't deliver fuel and spark if they don't get a signal from the crank position sensor
625 questions posted
Usually answered in minutes!
1,021 Questions
870 Questions
712 Questions
723 Questions
618 Questions