2001 Dodge Grand Caravan "cast middle" Questions

...middle to top of the wheel, with the wheel noticably at an angle and the strut bent. I was able to drive it home slowly and then on to the body shop. They only did visual check and think there was ...

...on the top-left side of the engine, the head casting should be on the left side head when looking from the back torwards the middle-bottom,and the crank cast should be behind the flywheel on the ...

...middle and work your way outwards alternatly ,alloy head around 65lbs ,cast heads slightly more say 70lbs unless its a turbo diesel with cast heads but dont confuse the issue,its american so it must ...

...cast block with a ball bearing in the middle in the 6 o clock position on the cylinder head. looking at it on the right side it is a cast almost machined straight edge up and down. On the left of the ...

where is oil filter located on 2004 6.0 excurion Open the hood. Its the black cap in the back towards the middle. It has a large nut casted to the piece.

...similarly to the 4 cyl.Although some have managed without, most people remove the intake plenum casting to get at the rear

...cast iron heads ,about 85lbs alloy heads 70lbs ,sequence start in middle and then one bolt to left and then one bolt to right ,just keep going left to right tightening them and you cannot go wrong ...

...on the road ahead. Since your driver's side cast down along the middle of the road further (probably) with the passenger side "flooding" along the side of the road, this may be the

...middle top then one to left and one to right till you reach the end of the head ,do it in two staged first with a rachet which will bring it down to about 40lbs then after doing all of them use nice ...

...engine with a cast head and push rods or a OHC engine ,if the first type then 75lbs if the ally engine then 65 mark ,start in the middle and then one each side alternatly working your way ...