torque spec of 180 foot lbs. is recommended. I highly suggest never using an impact for the hub to axle application. If you don39;t use a properly calibrated torque wrench you could have problems in
...bolts that hold the hub to the knuckle. 6. Rmove the hub. If you need torque specs let me know and i39;ll get them for you. It is absolutely critical that you torque the axle nut to the proper
torque the three bolts that hold the bearing to the knuckle and the axle nut to the correct torques spec. Failure to do so will cause premature bearing failure. Also use a good quality bearing. SKF is
...torque spec on front axle nut 2002 grand Am 284 ft-lbs. I dont remember the years but there is an updated wheel bearing form some suppliers. These will have an updated torque spec. If there was not a ...
...nut to the correct torque spec. Failure to do this will causing the bearing to fail early! Let me know if you have any questions and I39;ll do my best to answer them. Thank you for using
spec once the bearing has been replaced. Failure to do so will result in the bearing failing prematurely. It is also advisable to get a bearing from a quality, reputable, manufacturer. This is not the
Question about Cars & Trucks
...torque requirement unlessotherwise specified in the carton.Depending on the application, type of hub unitbearing and location, the installation process mayvary.Please review the vehicle ...
...torque spec of 180 foot lbs. is recommended. I highly suggest never using an impact for the hub to axle application. If you don39;t use a properly calibrated torque wrench you could have ...
...torque spec for front end cv axle nut to hub on 2000 Plymouth Neon Yes there is a torque spec of 180 foot lbs. is recommended. I highly suggest never using an impact for the hub to axle application. ...
941 questions posted
Usually answered in minutes!
861 Questions
762 Questions
743 Questions
710 Questions
544 Questions