2000 Dodge Caravan "v6 moter problems" Questions

moter will turn over, but will not start? motor will turn over, but will not start? sometime it will and when you put it in gear it quits. 2000 dodge grand caravan 3.3L V6 automatic tran 2 wheel dr.76

...V6 ENGINE and drove it 1 time now it wont start it makes a clicking sound wheb i turn the key over what could be the problem It would be easy to suspect a starter/solenoid problem if not for the ...

moter starts up an then cuts off after a few times of that it will run what seems to be the problem?? 4dr 2wheel drive v6 4.0 sounds like the fuel pressure release valve might be sticking.try checking

...moter is a v6 and it has wo vaulve cover gaskets. front one was easy to change- but i have questions about the rear one. what all needs to be taken off and is this a timely job. any suggestions on ...

v6 slips in gear when accelerating. if you dont accelerate and let it go on its own it will allow you to give a little acceleration and evenually catch up on speed one day i was driving in city limits

...moter or transmission or what Ok, it's not the transmission. P0101 maf sensor ( mass air flow) sensor. Change the sensor, it is located in the air intake hose that runs from the air filter housing to ...

...v6 motor. I think it might be coming from the power steering unit. The moter labors when you are turning at low speeds, p Has there been other people that asked about this topic.? Your asking people ...

...v6 4 motion loses antifreeze like crazy, every few days i need to add more antifreeze or water. what's up? if you have to add add coolent alot you have a rally bad leak do you knotice a puddle under ...

...V6 . The owner has told me that the heater only blows on high. Can anyone help me with this?? I am in Canada and will need this fixed as far as I know for an Insurance inspection. I will also need to ...

...moter that is a very common problem with the gm 3.1L v6. you will need to have your intake manifold gaskets replaced Could be just a heater hose or lose clamp.But you need to do a pressure test to ...