1999 Dodge Durango "valve tap" Questions

...valve tap but usually problems are the simple ones when it occurs all of a sudden. Check your spark plugs to make sure not loose and check to make sure any small black tubing isnt disconnected ...

valves tap..are they adjustable ???? The rocker arms on my 99 durango are non adjustable. The lifters are hydraulic units with a hydraulic camshaft.

the noise is in the bottom could be a piston pin or the crank shaft excessive wear in the bearings. Valve train ??? Stop the car.... you should not use it except to diagnose the problem (in my opinion

tcm or a gasket seal inside the transmission. Note: The solenoid and od wiring harness and pressure valve cover booster plate have both been replaced, and still the same code. What is causing this ???

...do to solve the ticking problem. did you have the heads worked at a machine shop (pressure tested, valves seals replaced and ground , and milled )? also how many mies are on the engine? the ticking ...

...some effort. The caliper ,or the caliper brake hose is bad,get it to lock up,then open the bleed valve on the caliper,if the caliper turns loose of the rotor,then the hose is bad,if it does not ...

...valves will tap.This tapping sound could be a lifter that's stuck or even valve lashes that have to be adjusted depending on how the tapping presents itself and the running

...tap, valve tap, and rod bearing noise. If you pull each spark plug one at a time, plugging it back in after each one, the tapping will go away if it's a rod bearing. At any rate, on your next oil ...

...cover I still can't find the tap with everything off Remove valve cover , start and run on low idle, adjust loud tappit. First turn in (clockwise) tap will get lowder then turn back til tapping

...valve tap. If so good additives just for both those conditions can restore the adjusting by cleaning and freeing the ailing parts. Try the link below for more info and needed product. Stops noisy ...