...definitely do it yourself. The following text is from the 2000 Durango service manual. The "Cowl Plenum" is some plastic on the front of the dash. For my 2001 I didn't have to remove that, It was ...
capacity freon refrigerant 134a There is a label under the hood on the plenum that lists the weight in ounces of the Freon charge.
...blows clod on passenger side flush heater core Sounds like a blend door problem inside the heater plenum box. Check out this website to see if your vehicle can ne repaired with one of their kits, ...
...turn it on slightly,run it over the vaccume line and any place the there would be a possible leak plenum gaskets and sensors when the gas is sucked in it will change the rpm of the
Still same problem. Any suggestions. I have a feeling that no one is checking the blend door in the plenum
...in running condition while spraying to confirm leak here. Replace all intake manifold gaskets and plenum gasket. If this does not confirm intake leak , have the Throttle Body cleaned manually by a ...
...Step 1: 12 inch/Lbs, (hand tight) Step 2: 72 inch/Lbs, (6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: 84 inch/lb (7) Ft/Lbs
...it's ALWAYS low. It's not burning it or leaking...? if it's 5.2 or 5.9 engine,the intake manifold plenum pan gasket may be drawing oil from lifter valley of engine..remove air cleaner and check
my 1998 dodge durango a/c does not get could at the front, but the back does. it can be vent or plenum door that is not operating properly its not sending the cold air to the front but to the back it ...
...to remove the blower. The resistor is about 2 inches x 3 inches and is installed in a hole in the plenum (duct) near the blower motor. It will have a wiring harness connected to it. It could be ...
3,011 questions posted
Usually answered in minutes!
1,616 Questions
1,378 Questions
886 Questions
1,005 Questions
766 Questions