...head I would like to say that the crankcase takes 5.5 us quarts of oil....BUT.....LET'S do it this way.....drain the engine oil....remove the old filter.....reinstall a new oil filter hand tight with ...
...head on a flat, clean surface with the combustion chambers face up, in order to prevent damage to the deck face. Remove the cylinder head gasket.Discard the gasket. Remove all remaining gasket ...
Question about Holden Cars & Trucks
...flat spots and lens out check light doesnt come on checked fuel pressure engine was running rough found blown head gasket changed when i done the valve timing with the dowl pin at twelve ...
that it and the block are checked for flatness otherwise a replaced head gasket (must be done if head is removed) may fail prematurely. If either is not flat, they must be resurfaced before reassembly
...flat, have the head vacuum checked for cracks. If it is drawing in coolant and the head and block surfaces look ok, most likely the head is cracked and will require replacement. If everything checks ...
Question about Cars & Trucks
...head gasket, water pump, and timing belt will round out the repair. With the right setup, it can be done with the engine in the vehicle....but it is easier to do with the engine removed (if you need ...
...head has been milled flat due to warpage, it is very possible that the valves are now too close to the piston. You will need either a thicker head gasket or pistons with releaf cuts to make room. But ...
...flat surface about 50 miles and have to cool off and put more water in. engine has small miss until warm or higher speeds. Head gasket,or head is bad,most likely. I agree the 4.6 NorthStar engine is ...
Question about Dodge Durango
...flat motor . It will be possible to remove the head while the engine stays in the car. The problem will be in the cam shaft timing so before you do anything bring the no 1 piston to TDC compression ...
Question about Mercury Cars & Trucks
...head, then support front of engine with wood block between crankshaft pulley and front subframe. 6. Remove righthand engine lifting eye bolt, then righthand engine lifting eye. 7. Remove power ...
3,011 questions posted
Usually answered in minutes!
1,616 Questions
1,378 Questions
886 Questions
1,005 Questions
766 Questions