1998 Dodge Stratus "replace cylinder head 4" Questions

...stretch during initial installation. New head bolts must be used when cylinder headis replaced or re installed to obtain proper torque specification. Hope helps (remember comment and rated

...head. after assembly checked compression, about 220lbs on all 4 cylinders. Started vehicle and when it comes down on idle motor shakes pretty badly like a miss. Pulled plugs wires while running and ...

cylinder what's the torque on it I gave it 50 pounds torque what if I retorque it again do u think ill get lucky and it will seal thank u Bad news, you have to take it all apart again, and replace

...side of cylinder head on transmission side .10 mm bolts to take out and put back in. 2002 caravan 3.3l camshat sensor been replaced code still comes back. says bank 1 or single sensor. any

cam sensor Is it easy to replace the cam sensor? Yes, it's on the rear of the cylinder head. 4 bolts and a electrical connector.

cylinder head is replaced or re installed to obtain proper torque specification Class action lawsuits are also involved in these 2.7 engines/vehicles...check it out: Chrysler 2.7 Liter V6 Engine Class

...cylinder should have been replaced at 100,000 miles. The belt on the V6 should have been replaced at 60,00 miles. At 60 mph you for sure are going to have some damage. How much damage, you will know ...

cylinder engine) and attached to thick wires, called spark plug wires. Cars with V-shaped engines (which can have four, six or eight cylinders) will have spark plugs and spark plug wires on both sides

...cylinder powerplant. The 4 spark plugs are all in a line on the side of the engine with the 1/4" + plug wires leading you to them. If there is a plastic engine cover over everything you may have to ...

cylinder motor in it this is a common problem for these motors,it will not necessarily be an external leak but an internal leak causing the motor to burn the coolant or the coolant is leaking into the