1998 Dodge Avenger "replace distributor" Questions

99 dodge avenger will not start. 2.5 V-6 engine Replaced distributor last time and solved problem. This time however replacing distributor had no effect. What else could be causing it not to even fire

Code says no cam signal on a 2.5. Is it the cam sensor and if it is where is it at? It is in the distributor. Replace the distributor.

...replace the distributor cap and rotor. ( Note if you have any doubt of the condition of the rotor or the cap replace them.) Next lets check your spark plug wires. Lets pull off one of the spark plug ...

...there is no spark at the distributor cap either take the distibutor cap off and replace the rotor. Its a small plastic piece with metel tips that turn on the distributor shaft...they wear out ...

I have no plug wire spark 1997 dodge average 2.5 v6 24 value.have already replaced crankshaft positioning sensor on it and still no spark to the wires Sounds like a bad distributor. Had you pulled a ...

...distributor out to replace with a new one and did not mark the position of the rotor button...how do I make sure I have the new rotor button in the corr I have a 1997 avenger 2.5 I have pulled the ...

replaced distributor and now the car runs rough just replaced the distibutor on my 96 dodge avenger and now it runs rough what the problem Check if your wires are in the right places. Had the same ...

...at the parts store... thats what mine was doing and replacing it solved the problem REPLACE CRANKSHAFT SENSOR FIRST. ITS LOCATED RIGHT BELOW THE DISTRIBUTOR ON THE TRANNY HOUSING MEETS THE ENGINE ...

I replaced the distributor, coil ignition module cam position sensor and still no spark in a 99 dodge avenger what could be the problem Often, modules and sensors are not the problem, rather the ...

THE 2.0 ENGINE. IF YOU HAVE A 2.5 ENGINE YOUR SPARK PLUG GAP IS 0.039 -0.043.IF ALL IS GOOD REPLACE DISTRIBUTOR CAP + WIRES AND ROTOR.SEE WHEN YOU REPLACE PLUGS ALSO GOOD TO REPLACE CAP AND ROTOR ALSO