1997 Dodge Dakota "replacing cam position sensor" Questions

...Position Sensor Circuit Intermittent Check the wire leads to the cam sensor and if that is in working condition, replace the Camshaft Position Sensor. Thank you for using fixya and good luck. Auto ...

but no spark. I've replaced the drive coil,(disc under the cap and rotor), and the ignition coil. Still no spark. crank position sensor or cam position sensor, also check if the wires are still intact

...cam position senor replaced had computer checked and replaced vehicle will turn over but not firing to injectors or coil something has shut it completley down It should have two relays that control ...

...cam position sensor repeat failure 2.5L 4 cyl. engine works perfect then no start. Engine cranks but no spark. Dealer replaced cam pos sensor located in the distributor and ran fine. 13 mos. later, ...

...position sensor, how do i know if its bad and is it hard to replace the crank sensor tell the computer were the engines crankshaft is positioned so it can make a spark and squirt fuel at the right ...

...cam sensor position when at tdc ? I replaced distribuator and cant remember At TDC the ignition rotor needs to be aligned with #1 on the cap. +/- 4 degrees. A scanner us helpful in determining the ...

position sensor.  Advance Auto etc has these usually in stock for about $50 you do not need to go to the dealer.  Looking for a cam pos sensor on the 1999 dakota is a dead end its called the

...position sensor. If you get a shutdown like someone just turned the key off, then this is a likely suspect. Fortunately, they are relatively cheap and easy to replace by the DIYer. Check the air vent ...

...Changed #3 fuel injector (per computer), crank shaft position sensor, cam shaft position sensor, smoke test shows no leaks, pressure test was fine. what is your problem.? is the truck not