Question about Saturn Cars & Trucks
cam shafts, where else?? called CMP sensor V6 3.6Liter? :USA. . but not all countries. non stated by you. there are 4 engines, which one. 2.8L up. I got bad news for you , there are 8 sensors, 4 cams.
...cam sensor? Most early 2 thousands GM models have twin cam sensors. One mounted on the front of the cylinder head and one at the back of the head.(4cyl engines) On V6's and V8's there can be 2 or 4 ...
cam sensor if its a 3.1 v6, then it is under power steering pump. to change remove pump but do not remove hoses. set pump aside, then you can see the sensor. remove the wiring then the bolt that holds
L or 4.0 L V6 engine, the cam position sensor is located on the top rear of the engine. If you have the 2.3 L 4 cyl. engine, you will find it on the left front of the engine behind the oil pump pulley
Question about Dodge Dakota
...error. Have a new sensor but can't find it. Since the cam sensor reads the cam position, depending on if you have a 4 cyl or a V6 engine, the sensor should be on one end of the cylinder
...cam sensor is replaced to sync them. The process requires a scanner than is capable of getting into the computer programs and using the CKP sensor relearn option. So most any major garage as well as ...
...sensor ,closest to cylinder 1. Bank 1 is the bank closes to cylinder 1. on I4 engines Cyl #1 is closest to the cam, and crank pulleys. on V6 /V8 Cylinder 1 is that bank that is most forward. on V ...
Question about Dodge Dakota
...cam sensor.
left as in left car door side,
i did not say drivers side, as the car is sold in UK and that be different side.
the left cam is that cam , on the left while the driver is ...
Question about Dodge Dakota
...cam shaft position sensor located 1999 hyundia sonata 2.5 Gary, Sensor is 3 to 4 inches above the starter motor on the V6 on 2.4 I4 engines the sensor is behind the timing cover if I am remembering ...
Question about Dodge Dakota
...cam sensor position when at tdc ? I replaced distribuator and cant remember At TDC the ignition rotor needs to be aligned with #1 on the cap. +/- 4 degrees. A scanner us helpful in determining the ...
1,012 questions posted
Usually answered in minutes!
1,021 Questions
870 Questions
723 Questions
618 Questions
593 Questions