1996 Dodge Stratus "replacing front axl joint" Questions

...front Drive axle for my 98 dodge stratus? remove the wheel, remove the axle retaining nut, remove brake caliper (to prevent damage to brake hose), disconnect ball joint at the spindle, swing spindle ...

front wheels off the ground i put the car in drive. only the right wheel turns at the normal RPMs the driver one doesn't only when i bring the RPMs up further but then it starts to clicking what could

front end noise turning left but not right. Half shaft or CV joint? I'd say constant velocity joint. It's been my experience that the offending side is usually opposite from the direction being turned

...front end. Got any ideas for me? Thanks....Becky You may have a cv joint about to fall out.To repair this ,the whole axle will have to be replaced.Axle is about 59.00 at NAPA auto parts.But do check ...

cluncking from the front susppension when I go over bumps its getting quite severe Shocks/struts need to be replaced. The strut bushings may be worn out or the strut shocks them selves, If you jack up

I replaced the struts on a 2006 Dodge Stratus . Had some difficulty with spring compression; anyhow when I was done and trying to test drive I heard a clicking noise and the car did not move. I think ...

...front of the vehicle. While I was replacing these things I had the brake line to the caliper unhooked, so the master cylinder for the brakes emptied completely. I filled the master cylinder and bled ...

...joint on front wheel drive axles allows variable power and speed ranges while the car moves along the highway. There is a rubber 'boot' that covers the cv joint to protect it from rain, snow, ice, ...

replace axle but not cv joints My Toyota sienna van shakes when accelerating at any speeds between 35-70mph. Dealer said axle needed to be replaced. My dad keeps talking about cv joints. Is it normal ...

...front u joint on the axle half shafts I am looking for info on how to replace the front u joint on the axle half shafts on my 2004 dodge ram 3500 You need to remove the front hub and bearing ...