1996 Dodge Stratus "jaw gear puller" Questions

...center and how to line up the marks on the timing gears when you put the new one in. Will need a jaws pulley type of puller, most auto parts will rent this tool out, harmanice

...jaw gear puller, a harmonic balance puller and many other tools most people dont have in their garage i cant do the timing on a dodge stratus it wont fire There are a lot of tools you need to replace ...

...gear just use the two jaw puller and wrap a ratchet strap around the puller to where the jaw puller claws are on snug and use the strap and tighten it down and screw in the center bolt use an inpact ...

...one with a pair of vice grips and a regular gear puller.You attatch the gear puller to the back of the adapter and use the vice grips to hold the puller jaws together and slowly pull the adapter

...gear puller 2/3 jaw. it still is not coming out the screw is not long enough. i got it from auto zone and they told me it was the tool to use the were wrong a three jaw that clamps around the outer ...

...jaw 5 ton gear puller that i used for my 2004 ford van w extra wide gripping surface that i picked up at Autozone WELL SOME EARLIER FORD VECHICLES, JUST REMOVE STEERING WHEEL MOUNTING NUT THEN ...

...You can use air tools(carefully), or to hold the balancer/pulley still, use a chain wrench with an old belt wrapped around to prevent damage. I would not recommend a 2 or 3 jaw type gear

What tool do I use to replace a harmonic balancer on uh 2001 impala A three jaw gear puller works fine. You have to lower the engine cradle down to get the balancer out. Just one side.

...jaw Gear Puller Screwdrivers Timing Light Timing Belt Cover Gasket Set New Timing Belt Drain Pan Antifreeze Jack Jack stands Take a look at this link as it is a walk through for a miata but the ...

...If you buy a new power steering pump, it usually comes with a nut,bolt and washer to install the pulley. The removal tool can be purchased and possibly rented at any parte store 6 Gear Puller 3 ...