What is the torque setting for the bolts on a transmission pan for a 1996 Dodge Stratus? 14 ft. lbs
...transmission fluid cooler line (1) and lower right side A/C condenser-to-radiator mounting fasteners (2) is possible after removal of the right fog light Fig. 13: Remove the A/C condenser-to-radiator ...
...14. Position the transmission jack. 15. Remove the bell housing bolts. 16. Remove the transmission. 17. Remove the flywheel housing bolts (8). 18. Remove the flex plate bolts (8). 19. Remove the ...
Question about Cars & Trucks
...torqe is needed for the transmission pan bolts? 14 bolt pan Torque isn't that critical on a transmission pan. !/2 turn past snug is sufficient. No need to squeeze the gasket by tightening too
...beam that looks to be part of the chassis, which would make it impossible to remove. The pan has 14 bolt holes,you will have to remove,the transmission mount to jack the trans up to access the
...transmission to oil pan bolts. 14. Remove the oil pan and the gasket. Refer to Oil Pan Removal. IMPORTANT: The low oil level sensor is not reusable. Use a NEW low oil sensor. 15. Remove the low oil ...
where do i find which tranny i have on a 97 explorer 4.0? If the transmission pan has 18 bolts, it's a 5R55E. If the transmission pan has 14 bolts, it's a 4R70W.
...bolt on the drain pan of the engine. (make sure its the pan connected to the engine and not the transmission as i have seen the transmission pans with a drain plug as well) It's a 14 or 15 mm... been ...
...14 pan bolts on the bottom of the transmission, leave a couple in until most of the fuild drains out. Remove the pan, and remove the filter. The filter and pan gasket should be under $20.00, and ...
...bolt to 40-55 Nm (30-40 lb-ft).NOTE: If oil pan is replaced with a new pan you must tighten new pan to spec then loosen and retighten. Position oil pan to cylinder block and install oil pan to engine ...
436 questions posted
Usually answered in minutes!
1,417 Questions
1,121 Questions
924 Questions
772 Questions
621 Questions