Question about Dodge Intrepid
...alternator, tighten the rear brace bolt to 22 ft. lbs. (30 Nm). Plug in the electrical connector to the alternator. Install the alternator front brace. Install the serpentine drive belt to the ...
...fan.Fit new belt. Slide alternator foward untill their is around 10-15 mm deflection in the belt, and tighten alternator mount bolts again to secure belt and tension. Recheck tension after about ...
How to replace a fan belt. Loosen the alternator and remove the belt. After you put on the new belt pull back on the alternator until the belt is tight and tighten the belt tension.
...Tighten the adjuster lock bolt and the alternator support nut. POWER STEERING BELT Fig. After the adjusting and fixed bolts are loosened, rotate the pump . . . Fig. . . . then remove the power ...
...alternator belt Hi there! Locate the tensioner screw beside the alternator itself. Loosen the screw and push the alternator until the belt is tight. Then tighten the screw. Hope you can fix it!!!
...Tighten alternator bolts and plug wires. Turn on engine and check that battery holding steady voltage. Hi, Disconnect the battery/unhook the ground cable from your battery, remove the alternator belt ...
...you move the alternator towards the flywheel to put the belt on, and away to tighten it up (you want a little deflection, but if it is too loose it will squeal - which is better than
... pull the alternator towards the outside of the loop the belt makes, then re-tighten the alternator bolts. If you can't get enough tension through the adjustment you'll need to replace the belt. Bill ...
Question about Dodge Intrepid
...pull the alternator so it puts tension on the belt, and then you can tighten it down. I have seen some vehicles that have a bolt that will turn in or out to either tighten the alternator or loosen
Question about Lexus Cars & Trucks
...the tensioner belt that is on the alternator on a 1998 Lexus gs300 just loosen the alternator on its track then pull it so that the belt is loose and remove the belt and replace then tighten ...
671 questions posted
Usually answered in minutes!
1,166 Questions
867 Questions
924 Questions
766 Questions
627 Questions