1996 Dodge Intrepid "engine timing" Questions

...engine.This means,if the timing belt broke while the engine was running,or you tried to start the engine,that the valves would be bent.So engine head rework most likely would have to be

the belt removed...Rotate engine by turning the crankshaft...Failure to do so will result in valve and piston damage... Guru..................Saailer hi cd 20 engine generator timing belt installation

...sprocket Timing chain Timing chain cover Crankshaft damper Fill the engine with clean engine oil. Start the vehicle, check for leaks and repair if necessary. Hope helps (remember to rate

...engine, it is behind the timing belt cover and driven by the timing belt. If you have to replace the water pump on a 3.5L I would strongly suggest replacing the timing belt at the same time. If you ...

...timing belt broke while the engine was running you could have bent valves at the least. Worst case scenario is that a valve hit the top of a piston and punched a hole in it. You could replace the ...

1997 dodge intrepid 3.5 engine problem. I have overalled the engine three times and changed the crank shaft two times and unfortunately engine now shaking too much, has a sound in piston no. 2. I ...

...engine out of the 2001 has a different timing gear on the left cylinder head then the one on the 1998. In 1998 the engine computer is a SBEC controler(single board engine controler) an the 2001 is a ...

...engine? timing belts are real common now and should be replaced according to mfgs recommendation, these are behind a cover on front of engine there are "interferance engines and non interference ...

...engine cranks but will not start. I let the car set between 20 min. and 4 hrs, it then starts, and runs like new. It has a new cam sensor, crank sensor, coil pack,spark plugs and wire set, a new fuel ...

Engine 97 Dodge Intrepid. Here is a few diagrams of the timing marks. Be sure that you check the marks after the tensioner has been installed as well because installing the tensioner tends to slightly