1996 Dodge Intrepid "crank not start" Questions

crank no start fuel pump supplying 60 psi to rail, no power to ignition coil but if cam or crank sensor no good why is there fuel pressure? check the asd relay swap it with another like it. also check

...crank sensor is tied in with the tach,try start and look at your tach gauge for movement if it move up and down crank sensor it's ok if not you have problem with crank sensor or electrical

...for your time. When you say won't start do you mean it will crank over but not fire off or do you mean it doesn't' turn over at all? We refer to this a "No crank no start" or "Cranks will not

...start for a while sometimes for a couple of hours. Is it the ignition switch, starter, cam sensor, or crank sensor? could be either the cam sensor or crank sensor , but I would check the crank sensor ...

...start, wont crank? or cranks, start -die allpar could have tsb data for you. or the public library, i look cars up on mitchell database there and get recalls/tsb's as well as pinpoint tests for

...start. This means there is no crank reference at the pcm the crank sensor is a common problem with that vehicle but I would be sure to check for bad wiring or lose connection from the crank sensor to ...

...not start. It ran fine before. Any suggestions? What do you mean, put in 2 bearings? did you measure the crank? bearing clearances? what do you mean by wont start? wont crank? cranks but wont

...start. I let the car set between 20 min. and 4 hrs, it then starts, and runs like new. It has a new cam sensor, crank sensor, coil pack,spark plugs and wire set, a new fuel pump and filter, a new ...

crank motor over by hand with a ratchet or breaker bar before attempting to start with key. You can very well ruin or lock up your motor if the timing is incorrect before you try to start with key. If

...crank at times but not start My 2000 dodge intrepid 3.2 is cranking but not starting. It happens usually after the car has run for a while. It is also stalling as I drive usually when it is at low ...