1996 Dodge Intrepid "cam" Questions

how do you set the cam timing on a dodge 2.7 liter, between the exhaust cam and intake cam???? HELP!! Here are the diagrams for the secondary timing chains (exhaust cam - intake cam) and the primary ...

this answer you gave to someone 6 months ago: ' The timing chain has jumped. It starts with the cam sensor unplugged because the ecm sees the camshafts aren't in time with the crankshaft. With

no start, no spark, no cam reference signal at pcm, has 5 volt supply at cam sensor and ground at cam sensor. I thought it would start with the cam sensor unplugged, it would just have a long crank ...

specs I need to know the correct setup position for the cam & crank for the timing chain. Also I need the torque specs for the caps on the cam. Well I just looked up the specs for you for the 2.7 ltr.

when i roll engine to TDC the cam shaft markes are on the bottom of cam shaft sprocket Turn the crank shaft ONE more full turn and check the cam marks again. This is because the camshafts rotate once ...

how to change cam positiom sensor in 2000 dodge how to change cam position sensor in a 2000 dodge intrepid and where is it located The cam position sensor on the 2.7 engine is on the driver side of ...

...WHAT OPIONS DO I HAVE?CAN YOU REFLASH COMPUTER TO READ NEW FLYWHEEL SPACING? REMOVE FLYWHEEL AND CAM SPROCKET? Does it start if you unplug the cam sensor? I'll bet it does. If yes then you will ...

CAMSHAFT SENSOR CAR WILL NOT START WITH SENSOR HOOKED UP when you unplug the cam sensor it runs?what that mean is that most likely your sensor is bad..reason for that is when your cam sensor is out ...

My 1998 Dodge Intrepid is starting & then stalling only after a few seconds. The engine light came on, & the code was P1391. Any ideas? My 1998 Dodge Intrepid is starting & then stalling only ...

...3.2 engine. engine serges at 3,000 rpm and will not get above 3,000 rpm. also will not start with cam sensor plugged in. new sensor first symptom sounds like mass air flow sensor,cam angle sensor ...