1996 Dodge Intrepid "96 truck shifts high" Questions

96 intrepid 3.5L with the 42LE automatic trans . the problem is after I park the car it won't shift from low to high . however , I can make it shift properly when I turn the ignition off then on again

...96 chevy 1500 4x4 it will shift into all gears just fine except overdrive i have changed the transmission fluid and checked all fuses what could it be i have a 90 chevy 2500 2wd 350ci.when i go to ...

...96 c1500 with the 5.7 vortec, the truck has trouble shifting and cruising at high speeds. it accelerates fine to a certian point then starts to sputter and backfire and has trouble shifting. sputters ...

96 s10 sonoma 5speed i went to shift to third gear and its stuck. even in neutral it still in third gear. What do i need done ? Did you try to pop the clutch? Did you mistakenly down-shift while still

...96 chevy s10 with an automatic transmission. It shifts hard through the first gear then when i push the gass real hard to get on the high the truck shifts out of gear and wonnt shift into the next ...

96 jeep cherokee 4.0 automatic has very high revs before shifting into next gear. once reaches 45 to 48 mph shifts into high. When you stop and start again it has high revs until reaching high gear ...

96 dodge stratus tranmission will not shift into high gear I changed oil and filter to see if that would make a difference but no luck all the gears work good but that one can only drive at 40 mph ...

96 Chevy Blazer will not shift into 4 wheel high. Had it on a lift and it will shift into 4 wheel high low but nothing on the dash or at solenoid on 4wd high. I removed harness and saw no corrosion. ...

96 chevy silverodo will not shift out of 1st until I let off the gas at high rpm then shifts to 3rd but that's it won't shift any higher You probably need to service the tranny as in change filter and

...96 dodge conversion van it won't shift into 2nd and high gear. Changed oil and filter. Do the bands need tightened up? What could be the problem? Bands are adjusted when you first rebuild a unit ...