1996 Dodge Dakota "locate fuse ac heater" Questions

ac control switch only works in the high position. You probably have a bad blower resistor. it's located next to the blower motor under the dash. Heater switch will not work on any setting Fuse is OK

92 dodge dakoto 5.1 4x4 fan not working/can"t locate fan is not blowing on ac/heater fuse ok. can't locate the fan motor. http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800712d3

heater fan problem this past weekend. The fan just will not work. The AC clutch works, the vacuum chambers all work, all the fuses are good. The fan will not work at any speed. Any ideas? Where is the

...ac arent working, is it not blowing air? first check the fuses and if they are good then get a test light and unplug the fan motor. using the test light probe the hot side of the plug while you turn ...

...fuse for memory power/no back up power radio & ac control now its not a 1988 but a 1091 olds, and not a Dakota. im totally gobsmacked. what is it, below is Dakota answer if it is an Olds what ...

...I can't find the fuse for the heater blower. Dose anyone know where it is located? the heater blower motor is run through two fuses. the gauge fuse in fuse block 1 and the ac fuse in fuse block

...should be? The fuse for heater/ac fan is number 36.30 amp located end of dash If this is ok,you need to replace heater control module behind heater controls.Save money buy haynes manual,check e ...

...ac does not work either. This is probably an a/c,heater relay,or fuse, usually located under the hood , in a covered fuse box. Check your vehicles owners manual for the exact location of your fuse ...

...AC in the fuse boxes located in the passenger compartment and the under hood fuse boxes. Wait for a few minutes and then reinstall the fuses to their correct locations ( Take a quick picture of the ...

...ac/heater blower not turning off . I can not find the fuss for this anywere. there are three fuse boxes in that truck one on the driver side,one on the passenger side and one under the hood i would ...