1994 Dodge Intrepid "bad turbine sensor" Questions

...but the car wont shift. Any suggestions? Check for codes, may have a bad speed sensor either input(turbine) or output (vehicle) speed sensor. They are a common problem with the Chrysler

...a no circuit and malfunction codes along with gear ratio incorrect. my question would be is the turbine impute speed sensor hard to replace? Usually not too bad on the side of the transaxle ...

...Turbine is the clutch sensor. (input rpm to trans-clutch) and counter gear is tail shaft sensor.? (output speed) so the front clutch sensor is dead or being grounded out, or is not connected, (rusty ...

...bad wiring issue in the circuit. When this happens, the subsequent P0721 output speed sensor and P0705 transmission range sensor circuit malfunction error codes appear- and does not necessarily mean ...

...Turbine input shift speed sensor is bad. Chances are that this sensor is located in the transmission or has access to it outside the housing.Take the car to a transmission specialist and have them ...

Turbine Speed Sensor is bad. Car transmission thumps when gear shifts. Turned off sensor and thumps stopped. that's not how it works. when pcm receive bad component signal short or open sensor it code

...bad volt. reg. being part of the ECM, I replaced that. The second code it showed was for the turbine speed sensor Input side... After replacing the ECM this code came back...so saving serious money i ...

no acceleration code p0715 and p0720 P0715 Input/Turbine Speed Sensor Circuit Malfunction P0720 Output Speed Sensor Circuit Malfunction These codes are indicative of bad speed sensors.

turbine shaft sensor be on a ax4n tranny?i bought a manual and it is no help... its giving the codes p0715,p1901,p0505..very hard shifting going down the road..drove home in third gear and it did fine

...Turbine Sensor may be the one closest to the engine and is any indication of input speed from the converter, vs: the other trans sensors that are farther back on the case. Now the issue is, can you ...