1994 Dodge Caravan "check engine oil pressure 80" Questions

...CHECK OIL PRESSURE IT SHOULD BE 30 - 80 PSI AT 3000 RPM.IF NOT YOUR OIL PUMP PRESSURE REGULATOR FAULTY.IF ALL IS GOOD OIL + FILTER BEEN CHANGED.POSSIBLE CAUSE TO NO OIL FLOW TO THE ROCKER ARMS COULD ...

...check with a gauge. Oil pumps are not easy to replace so lets make sure it is the problem before replacing it. For reference yours can be done with the motor in the vehicle. Physical Pressure Test: ...

...Engine/AC run for at least 5 minutes. Check the guage again. Ideally, you want the gauge to read around 35 to 40 at idle. DO NOT GO OVER 45! You will kill your compressor when running almost ...

engine is running then start replacing the oil filter, and check that the oil lines from pump are not obstructed, if there is nothing in there then replace oil pump. If instead the gauge reads 80 with

...engine to check on the pressure.Any pump can push 80 psi if the relief spring is defective but if the pump is high volume unit,make sure you have an extra capacity oil pan or you may empty the pan of ...

...80 should I drive it cant get in garage till tomorrow, driving about 60 miles? 80 is ok unless it says 80 when the engine isnt running,turn on ignition and check the oil pressure,it should read

...engine oil pressure is too low. If the oil pressure is too low, the check gauges tell tale will turn on. The oil pressure sender is located on the left side of the 2.2L. The 4.3L engine, oil pressure ...

...engine block, The switch is beside the sump,disconnect the switch and check if the lamp has went out,if it has replace the switch,if it hasn't replace/repair the wiring. The switch shorts and the ...

...check engine light comes on oil pressure gauge goes to no oil pressure. all other gauges were fine , not over heating and running fine. pulled over checked oil has plenty of oil. brought home let it ...

...oil pressure zeroed and not much power from engine, any thoughts? No damage will occur. Have you checked the oil pressure with a manual test gage? If not do that and please understand GM oil pressure ...