...having to push my clutch all the way to the floor in order to shift gears, and it is getting harder to get into the right gear. If you have replaced your clutch/pressure plate...you need a new
...clutch all the way down to the floor board, this is not an exaggeration, I have to push it all the way down in order to shift. I don't think I should have to do this, but maybe it's just that ...
Question about Dodge Dakota
...clutch pedal sticks to the floor and either after a while it pops out or sometimes I have to pull it up myself. Both of these problems have caused sometimes make the car refuse to go into any gear at ...
clutch system you need to push or pull the air down through the fluid line to the bleeder valve on the slave cylinder. To keep things clean you should attach a tube to the nipple on the bleeder valve.
...push on the gas and sometimes the rpm goes to 30 but im not even moving and it just takes off on me. sometimes i think its leaking gas or something but everyone i go to tell me its fine. but i can ...
Question about Dodge Dakota
...clutch petal depressed to the floor board. I pulled my vehicle over due to not being able to engage any gear. I sat there for about ten min and realized the clutch pedal would go down about an inch ...
...push type) and I am running stock GM clutch hydraulics (replaced w/new back in 2006. Trans (t-56 6 speed) shifts fine when the clutch is depressed and engages strong when the pedal is all the way up, ...
...done get in the car and push the gas all the way to the floor. This will set the correct position. Hope that does it. So you have 1st, 2nd, and reverse? If so, 3/4 clutch pack burned up. See this a ...
834 questions posted
Usually answered in minutes!
1,021 Questions
870 Questions
712 Questions
723 Questions
618 Questions