1998 Buick Park Avenue "start truck twice oil pressure" Questions

...start my 1998 Park Avenue, I get 2 messages. The first one says, "Check tire pressures." The second message says, "Change engine oil soon." I have already had my tire pressures checked and have also ...

...oil sending unit. It ran good when I got it back but a week later it started going dead while driving. If I let it set for a few minutes it would crank back up. It done this for a few days with it ...

...twice in this vehicle. If it were me, here's what I think. I installed a new Ignition Module back in May, but I think it's defective, it's gone bad already. The engine suddenly stalls when it reaches ...

...start. After several hours it starts right up. Towed to dealer twice, started ok numerous times with no codes. Can't trust it. 3.2 6 cyl. Purchased new and now shows 103K. Cranking with no start ...

...engine make a bad noise, like it is not getting oil? If not, I would try replacing the oil pressure switch. I have had to do this twice in the past three years that we have owned my wife's 02

...start to flash, now press and hold the reset button until you hear chimming hold until chimming stops then release, the change oil light should go off. If you need to reset tire pressure press reset ...

...Twice since my oil pressure gauge reads no pressure but not all the time? Why 1. Oil Pressure Gauge Not Working You will notice this happens when your oil pressure gauge is not reading, whether the ...

...Twice in two years now my Saab 9-5 has had a pin-hole in the oil cooler, which has caused oil to flow into the reservoir. A way to tell is if coolant/oil is coming out of the reservoir cap. The ...

...truck. Running fine change the oil, oil filter,gas filter and know it won't start. When it did it back fired twice. There's no check engine light what happened? Changing the fuel filter releases the ...

...truck since then, scared of seizing the engine. Could the oil screen just be sludged up? Or maybe the pump has gotten clogged? Or is it bigger issues? Would like to know more before I go replacement ...