1998 Buick LeSabre "remove starter lesabrer" Questions

...car locate the starter, but first remove the neg terminal from the battery. You will see two bolts holding the starter on. Remove these. Remove the battery wires from the starter and replace new

...two bolts keeping hold of starter to prevent it falling and remove starter. Replace new starter and it's two bolts, wires and nuts as previously hooked up, and then battery wire, and carank

...remove two starter bolts from bottom of starter up into engine block. Starter is free now, and can be tipped, twisted, or turned for removal from engine area. How you manage to get it out from the ...

...behind radiator The starter is under the front of the engine on the 3.8 V6 models and has to be removed from below. Make sure that you dissconnect the battery posts first before

...remove a starter rom a 98 buick lesabre..i have the car jacked up on ramps but am confused to how to get the starter out The starter is on the front of the engine, towards the transmission. There are ...

...Remove starter braces, shields or other components that may hinder starter removal. Support starter and remove mounting bolts. Lower starter and disconnect solenoid wires and battery cable. Remove ...

...before u start the work!, then remove the wiring from the starter solenoid, 4 wires i think, make a note of where they go for re-assembly, remove the two bolts and drop the starter out, very

...security system fault on 1995 Lesabre preventing starter from activating. How do I disable the starter-kill function? Remove teh power from the Viper Control unit and the Starter Kill will

STARTER NOISE DURING CRANKING: REMOVE 1 - 0.O15" DOUBLE SHIM OR ADD SINGLE 0.015" SHIM TO OUTER BOLT ONLY. HIGH PITCHED WHINE AFTER ENGINE FIRES: ADD 0.015" DOUBLE SHIMS UNTIL NOISE DISAPPEARS (NOT TO

...the battery, Remove the rock shield (black plastic). Disconnect the wires, remove the two bolts at the rear (driver side) of the starter and bring it out Pull forward, tilt it down it should come ...