Question about Cars & Trucks
...torque converter to the flex plate as the torque converter should be pulled with the transmission and not separately make sure that there is not a bell housing bolt from the front going back into the ...
...Torque converter access plug 4L60E/4L65E removal Flywheel to torque converter bolts The two bolts securing the transmission rear mount to the transmission The transmission vent hose, fuel lines, and ...
torque specification on a 2003 alero cylinder heads 3.4 liter 3.4L EngineTo Remove: Remove the lower intake manifold. Remove the exhaust crossover pipe. If removing the right cylinder head, remove the
Question about Buick Skylark
...torque converter on as it must be refitted with the torque converter located onto drive input shaft as their are two flats that pick up the drive .If you try a direct question to emmisionwiz iam sure ...
Question about Jeep Cars & Trucks
torque converter loose from transmission on my 95 jeep grand cherekee can you tell me how to do it did you remove the flywheel bolts?? Well ill assume your issue is how to keep the engine from turning
...torque converter hub it may be cracked . to remove the front pump drain transmission remove pan remove filter & tcc solenoid and oil control line early 95 trans. then place tail shaft down and ...
...torque converter relationship to insure proper alignment upon installation. Remove the flexplate-to-torque converter bolts. Remove the engine support bracket-to-transaxle bolts and the bracket. Lower ...
Question about Buick Skylark
...torque converter. Turn the crankshaft to gain access to all 3 bolts. NOTE Remove the radiator upper fan shroud and the cooling fan to access the crankshaft center bolt to turn the crankshaft. Place a ...
...torque converter bolts or nuts 7remove all the bolts attaching the trany to the engine make sure you have a floor jack to receive the trany when it fail down do not work under the car or check it to ...
...torque converter or clutch inspection cover. Support the oil pan and remove the mounting bolts. Lower the pan and remove the old gasket, if so equipped. To install: Clean all gasket surfaces ...
504 questions posted
Usually answered in minutes!
224 Questions
182 Questions
155 Questions
143 Questions
87 Questions