1997 Buick Park Avenue "fire ignition coil" Questions

...coil pack. With Type I Ignition With Type II Ignition or... Good luck. i have an 89 buick park avenue and it cruises good, fires good , idles good but when out on the highway and going up a hill it ...

...4; no fire at coil; Ireplaced the coil; stillno fire on 1 and 4 new coil and no fire? test the ohm rating of the all coils old and new. It maybe the ignition module can be at fault or a bad new ...

...Ignition Coil Removal & Installation To Remove: Ignition Coils Before servicing the vehicle, refer to the service precautions in the beginning of this section Disconnect the spark plug wires from ...

i have a 1991 buick park ave ultra,what is the firing order The firing order is 1-6-5-4-3-2 and the ignition wires will attach to the ignition coils according to what type of ignition system your ...

sensor still no fire i change the crank and cam sensor ignition coil still no fire asd relay or fuse camshaft not spinning bad pcm damaged wiring harness motor turns no fire to plugs on 1996 buick p.a

...ignition coils.Take a multimeter and remove the plug wires.Now the coils are all paired so you need to set your multimeter to read ohms.MEASURE THE RESISTANE ACROSS EACH SET OF COILS.They should all ...

...ignition coil and coil pack strip still no fire getting good fuel pressure but no fire will not start fuse are good did computer check got a code p1626 P1626 Theft Deterrent Fuel Enable Signal Not ...

ignition module I just need to know how the wires from my control module match up to the bottom of my coil pack. I have a 91 Park Avenue 3.8l with the single unit for the coil pack NOT the three ...

cylinder misfire coil I thought the coils in my Buick (3800)were bad cause #3 was firing intermittently. So I changed the #2 coil with the #3 coil and also changed the igniter. I worked for a day the ...

...ignition spark issue.....my car will not fire on the lowest coil in the coil pack. i have changed the coils and also moved them around to ensure not a faulty coil. i just put an ignition control ...