1997 Buick Century "probe" Questions

...can see the connector in the picture below of the resistor/relay assembly. With that connector off, probe the terminals in the connector with your test light or voltmeter. Turn the key on and the ...

How can I tell if electrical problem is alternator or battery on 1998 buick century? Easiest way - You can connect a good battery to your car (borrow a friend's) - if it cranks over and stays lit

...But, 3 months went buy before the low coolant light came on. the problem is in most cases in the probe for low colant light try to clean it if that dont work replace it. good luck. ...

...now Check the wiring connector Your getting a low voltage reading, as if the sensor was closed Back probe it with a volt meter & move the throttle plate with the ignition key on & look for ...

battery drains must disconnect and reconnect the batery every day and every night where do i look for a common short This is a very difficult task. One way to narrow the possibilities is to connect ...

...distribution block have power to them. Use a test light, clip it to negative battery post, and probe the tops of the fuses for power. There are two little slots on the tops of the fuses-put the ...

...to see if the light goes out (allow 15 seconds or so). If it does, then remove and clean the copper probe of the sensor with a scratchy pad and reinstall. If the light comes back on, then replace the ...

reenter, i am Not getting the ecm ground to activate the solenoid if i apply a ground with my power probe to the green/white wire it will activate, The pink wire has 12volts key on and when i plug the

...be on between red and white. Remove the vent and carefully apply 12v power to connectors with long probes +12 goes on red wire side. If it click take a long strong needle and CAREFULLY pull out and ...

89 ford probe hesitates when leaving a red light, then runs fine otherwise, fuel filter? Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard ... repairpal.com > Problems > Ford > Probe Ford ...