1997 Buick Century "blower motor fix" Questions

...BLOWER MOTOR RESISTER" That is where I would start. Ken, If that does fix it. I would replace the blower motor as well because its usually the high resister within the motor that actually causes the ...

blower motor resistor fuse blows everytime i turn my fan on high and wont work on any other settings, if it is the blower motor resistor how do i fix it? Your blower motor is starting to fail, and ...

...blower motor speed control resistor 1st then the blower motor if the resistor doesn't fix the problem. Below are instructions to replace the resistor. The blower motor resistor is located on the back ...

...blower motor control with a new one but that didn't fix it. The heat and ac work fine, It's just that the fan only works on high, no other settings. I a wondering now if the fan might ...

...blower motor resistor The fan switch in high position, feeds full 12 volts to the blower motor. Lower settings rout power through a blower resistor or resistor modual, usually located in the heater ...

BLOWER MOTOR. TO CHECK THAT JUST UNCONNECT THE ELEC CONNECTION CHECK FOR 12V WITH KEY AND SWITCH ON. IF VOLTAGE IS NOT THERE CHECK MAXI FUSE IF IT IS THERE AND MOTOR ISNT WORK IT MUST BE REPLACED. OLD

...Blower Motor Resistor I am having problems with the blower motor resistor on my 1997 Buick Century Custom. I think that I found it under the passenger's glove box, but I am having problems getting at ...

...blower motor. The resistor is located on the firewall inside of vehicle on the passenger side. If I remember correctly it is a bit of a ****** to get to the screws. Also if you have automatic ...

...myself or have it fixed by a mechanic You have to replace the blower motor. They don't use resistors anymore, each motor speed connects to a different spot on the motor windings to control the

...blower motor resistor on buick 1999 I just fixed my 98 and expect your is pretty much the same. The resistor module is located in back of the blower motor, very close to the firewall. Just follow the ...