1996 Buick Century "grease electric drills" Questions

...eLECTRIC WINDOWS One of two problems. Window motor or window regulator. Began by removing the door panel. Peel down the vapor barrier. This will expose the motor, you will see three star screws, ...

electric window back on track First remove the door panel. Then peel down the plastic rain bearer. You should see three stsar screws which holds in the window motor. Remove these and remove the window

...the safest way to clip the new ones into place is to put them in the rail, and slowly squeeze the greased ball into the socket using a "G" clamp. I greased the rails and presto the windows worked ...

The new coil will have bolts instead of rivets.Remove the coil wire from the old coil.Make sure and add die electric grease to the coil wire.It will be included with the coil.Hope this helps.Good luck

electric drill and some drill bits to drill out the 5 rivets. There are two bolts that attach part of the window regulator to the door. These need to be removed as well. Once the rivets and bolts have

...Grease D0AZ-19584-AA or equivalent. Install regulator into access hole in inner panel. Position regulator using upper regulator studs and tabs on motor mounting bracket (electric) or cup mounting ...

...Grease all of the sliding surfaces of the regulator or component failure may occur. To install: Install the window motor on the regulator assembly. As a check, you can connect a known good 12 volt ...

...electric drill on it, and suction the excess out. Messier, but effective is to loosen the bolts on the pan on the bottom of the transmission, and let the excess leak out into a tub. If the ...

...electric drill and drill the bolt out and replace it with new. When you say it's stripped do you mean the threads are stipped and it spins but won't come out? Or, is the head of the bolt or screw ...

...electric drill down into the oil pump drive slot (distributor removed). I actually use a distributor that has the top cut off without the cam gear, and just attach the drill to the shaft, but the ...