2001 Pontiac Bonneville "impact driver replace tire" Questions

...impact driver, go buy one.) Next, you remove the brake caliper and disk. You can then use a hammer/punch to free the end of the axle from the wheel bearing (you probably do not need to completely ...

driver shock tower I HIT A TURN LANE DIVIDER, AND MY TIRE WAS LOW SO IT DIDNT ABSORB ANY IMPACT AND THE IMPACT WENMT THROUGH MY STRUT AND CAUSED MY DRIVERS SIDE SHOCK TOWER TO RISE 1 INCH good ...

...impact drivers OVER-tighten the nuts so that within a shorter than normal time the heat/cooling of the wheel causes the studs to loose their tensile strength and break- specify the next time you have ...

...impact with tire being pushed in towards the strut assembly. shocks are fine minimal damage to body I don't see a question here... You know what's bent... Replace it, and have the front end aligned ...

...driver side tire to be making a noise and slowing my truck down, even when going down a hill! The hub assembly for the wheel was replaced a few months ago. It almost feels like a brake pad is rubbing ...

...driver side? That was quite an impact to do that kind of damage. I would suggest that you have an auto body shop look at you vehicle to determine if it is repairable. You may have a problem setting ...

driver side front axle is loose at the inner end. can I drive it til replace this weekend? Boots not torn, no clicking. About quarter inch play in wheel. Some buzz/whine sound randomly that disappears

impact like a pothole. I had one bent by a tire shop one time when they put a wheel nut on with an impact gun before the wheel was seated properly on the hub. Might be time for a second opinion from a

...driver side tire off and tried to remove the caliper bolts and the darn things are stuck on there waaaaay too tight. It's on there so tight that it cracked my socket when I was trying to remove it. I ...

...DRIVER SIDE TIRE AND THE STEERING WHEEL SHAKES TERRIBLY...I JUST HAD AN ALIGNMENT DONE...WHAT COULD BE THE CAUSE? Could be a few things.. Front end parts, ball joint, maybe they forgot to tighten ...