1990 Nissan 300ZX "starter bendex" Questions

...the starter so the bendex gear in the starter engages with the flywheel/flexplate. as long as the bendex gear in the starter comes out the casing and spins shimming it will take care of that ...

...and on the driver's side. Any ideas? most probably starter motor bendex. bendex runs in bush witch gets dry and starts making a noise. starter must be removed and bendex/ bush surface

that The bendex (starter gear) spring is bad or the shaft it rides on is very dirty. If you have the skill to tear down the starter then you can replace the bendex. If not, it's time for a new starter

...Eather your bendex is not kicking out from the starter into the flywheel, Or it is possible you have a few teeth missing on the flywheel. Most likely it is the starter bendex spring not ...

bendex drive gear engages with the fly wheel then the starter is bad its nit switching inside it and you just by passed the bad switch. If the bendex drive dosn't engage then the solinoid is the cause

starter disengage? Usually the bendex motor is worn out. That motor pushes the shaft into the flywheel as the second main motor "the starter" spins the engine. I had this problem in my 1997 Saturn SW2

...starter back out and run Jumper cables to the starter. See if the bendex will kick out and stay out untial you diconect the starter......Sorry for your run of bad luck and I hope this is of some

...starter bendex trying to engage the flywheel. The starter may check out ok, but the bendex is turning but coming out. The starter will need replaced. Hey the pitched spinning noice sounds like ...

...me, maybe the bendex gear?? do i need to change the whole starter? You have to remove the starter and the starter drive is a part inside the starter. It's easier to just replace the entire

...the silonoid from the starter and sand the bendex in the silonoid with some fine grit sand paper and use air to blow any debres out of it and reinstall silonoid and it will get u by for a short