2006 Mitsubishi Colt "hose retract caseing" Questions

Ad

Question about Mitsubishi Colt

4 Answers

...hose expanding internally and acting as a valve, allowing fluid to pass to the brake but not return. Thanks all for the feedback The piston on the calipers is very stiff - was very hard to retract Is ...

Ad

Question about Mitsubishi Colt

1 Answer

...retract with vacuum applied causing doors to open or close. Begin with ensuring the vacuum hose from the engine has vacuum at the back of the heater controls with engine running-just pull off the ...

Ad

...is sticking and the front passanger brake too, i cant figure out why. Replace both front brake hoses.....they collapse on the inside and will not allow fluid to retract...caliper was probobly ...

...hose). if it does not retract, caliper piston may be frozen, or the piston cocked in the bore while you were pushing it back in. If that's the case you can rebuild it, but the price on most reman ...

Question about Cars & Trucks

1 Answer

why does drivers side floor stay wet You don't way what type of vehicle you are driving. I will assume it has a sun or moon roof. Most of these have drain lines that run down inside the driver's side ...

...assembly onto the rotor and that does not work either. Please help youll have to clamp the brake hose,undo the bleed screw,and push the piston[s] back in,then shut off bleed screw,undo clamp on ...

Question about Mitsubishi Colt

4 Answers

...then front brakes stuck on, very hot and smelly. Garage have replaced.... Pads (again), calipers, hoses, master cylinder and now talking about replacing servo(?), not quite sure what this is, but ...

Question about Mitsubishi Colt

3 Answers

...was inside the front diff. That vacuum actuator that sits on the passenger side that has a vacuum hose going up to it has a built in cable that plugs into the front diff. There are little springs ...

Question about Mitsubishi Colt

1 Answer

hose may be damaged. At this point, you will be able to remove the brake disc by hand. However, rust may have a firm grip on the disc. If this is the case, use a couple of 8-by-1.25 mm bolts and screw

...or take it to a competent mechanic very close to home who can check over the installation work. (Those that did the work should have road tested the car before giving it back to you and binding ...

Not finding what you are looking for?
2006 Mitsubishi Colt Logo

369 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...