2004 Mitsubishi Endeavor "rubber actuators" Questions

...does not work. All the other doors will lock,and unlock with the key fob. check the wires in the rubber boot between the door pillar and the door for a break in the wire or loose plug socket

...cap. Push back release rod - 9 - by operating remote control unlock and remove bolt - 2 -. Remove rubber part - 8 - from tank filler flange and swivel out tank flap unit - 1 - from side panel - 7 ...

...drive actuator. it located under the battery. The actuator uses suction to open and close. if the rubber housing has and oil residue on it, the oil will eat the rubber causing a hole, where there ...

...drive actuator. it located under the battery. The actuator uses suction to open and close. if the rubber housing has and oil residue on it, the oil will eat the rubber causing a hole, where there ...

...remove switch. to remove mirror open passenger door pry off small trim plate behind mirror remove rubber material disconnect small wire remove 3 nuts and remove ...

...the transfer case they have a tendency to stick or jam check for power at relay than actuator use a rubber or medium head mallet and tap on actuator careful of connections if still stuck remove and ...

...is on side of transfer case check wiring and connections at actuator if good than u can use a rubber mallet tap around actuator to loosen any road debris which sometimes works but the best is

...panel to My 1996 Honda had the same thing on the driver side door. It was caused by a deteriorated rubber stop inside the door lock actuator module. The module is buried down in the lower outside ...

...believe the 4 wheel drive is engaged by a vacuum actuator on this model. Look under the hood for a rubber "banjo-like" diaphragm that has a cable coming out of the middle of it. If I'm right, you'll ...

i have a 1993 cadallic fleetwood the inter lights come on all time we have to hit the door to get them to go off Door switch actuator or little rubber bumper on actuator is offf