2004 Mitsubishi Endeavor "fixya hvac" Questions

fixya.com/cars/t2592290-air_conditioner_drain_plugged First make shure its not just water vapor first whats it leaking the low side were you drain R12 out if you have to much in it the low side bottom

...HVAC/RFA/CLSTR/ALDL (15Amp) and see if the fan shuts off - if not - try the BMCP fuse HI/BLWR (30Amp) - Both are listed listed at the top of the schematic. Thanks for using FixYa - a FixYa rating is ...

HVAC control module please? A/C blower motor stays on with car off. Question edited for clarity. Check out the previous Fixya question with answer, and the other information in the link. It is a known

...hvac syatem. Is there a reset that needs to occur or?? Thanks, Robert Hi, The reason for the display to be on is loose wiring. First check the wiring, connectors and connection clips to the abs ...

...of the time this will save you from buying a new switch. keep us posted and thanks you for using ...

...HVAC to re-calibrate when ignition is turned to the "RUN" position. There it is...Good luck...hope this helps, please rate me a fixya The control for the vanes that direct air flow to where you want ...

...to your other post : http://www.fixya.com/cars/t3532010-05_ford_150_electronic_automatic The control module is the HVAC panel on the 2004-2008 MY trucks. It is built into the control module

...HVAC unit is faulty. For replacement part, coould check THIS LINK: Blower-Motor/Buick/ParkAvenue Welcome to FIxYa.com Are you talking about the blend door from a/c to heat? Thank you for using ...

fixya.com/cars/t1580493-hvac I pulled out the blower motor - measured well less than 1 Ohm across the blower contacts. I measured the voltage across the wire harness connectors to the blower, but even

...hvac reset did not work you have a trouble code - reset BCM There are two ways to reset your body control module Go to the GENERAL Remove BOTH battery cables (for the sake of CAUTION remove air bag ...